Take 2" wired ribbon. Cut a piece as long as your arms
Pull out one wire.
On the other wire place tape at one end. The tape is to make sure that you don't pull the wire all the way through.
Pull the wire from the other end until the ribbon is all bunched up. Place tape on the end that you were pulling from right next to the ribbon. This will hold the ribbon all bunched up.
Place the ribbon in a circle. Mine completed 3 circles
Pull the one of the wire through the middle hole (in the middle of the circle)
Twist the wires together and remove the tape.
Hot glue the flower onto a ribbon lined clip.
Enjoy!
